UNIVERSAL (PAIR) DUAL-TILT RAM MOTOR SUPPORT VERADO'S AND MERCURY V10

INSTALLATION INSTRUCTIONS FOR DUAL-RAM POWER TILT SYSTEMS

 

 

  1. Trim outboard to up position.
  2. Simply push the Universal m-y wedge on the power-tilt rod and it will pop or click into place.
  3. Trim outboard down until the rubber begins to compress.
  4. To remove Universal m-y wedge simply trim outboard to up position and remove.
  5. Store Universal m-y wedge in any boat compartment for convenience.

 

NOTE: The Universal m-y wedge can be cut to size, if your outboard sits too high or you have problems with tilting your motor high enough to install the unit. Simply cut the Universal m-y wedge using a miter or hack saw. You normally don't need to cut off more than an inch.

WORKS ON:

  • Dual-RAM tilt outboards.

  • Mercury Verado (ALL Dual Ram) uses 2 Universal units. 

  • Mercury V10  Uses 2 Universal units

Mercury Verado use TWO Universal m-y wedge units.