Single-Ram Power Tilt Systems

INSTALLATION INSTRUCTIONS FOR SINGLE-RAM POWER TILT SYSTEMS

  1. Trim outboard to up position.
  2. Simply push the Universal m-y wedge on the power-tilt rod and it will pop or click into place.
  3. Trim outboard down until the rubber begins to compress.
  4. To remove Universal m-y wedge simply trim outboard to up position and remove.
  5. Store Universal m-y wedge in any boat compartment for convenience.

NOTE: The Universal m-y wedge can be cut to size, if your outboard sits too high or you have problems with tilting your motor high enough to install the unit. Simply cut the Universal m-y wedge using a miter or hack saw. You normally don't need to cut off more than an inch.

WORKS ON:

  • Mercury 15 to 200 hp 4-stroke with single-ram trim/tilt
  • Yamaha (9 to 90 hp and new F115LB)  with single-ram trim/tilt
  • Honda with single-ram trim/tilt
  • Suzuki with single-ram trim/tilt
  • Evinrude with single-ram trim/tilt
  • Johnson with single-ram trim/tilt
  • Tohatsu with single-ram trim/tilt
  • Kicker motors with power tilt systems.

Mercury Verado 6-cylinders use TWO Universal m-y wedge units.